Solar Charge Controller 12V/24V Auto PWM 30A
The HP2430 is a state-of-the-art charge controller based on PWM controller and designed to manage the energy generated by solar panels and to recharge connected batteries and give energy to the load.
Its use is for solar installations without connection to the network, it controls good functioning of the solar panels, the batteries and the connected load.
The controller has an LCD display that shows in real time the status of the installation, the operating parameters, the controller registers and the configuration.
You can check and modify the parameters directly in the regulator.
This regulator uses the Modbus communication protocol, so you can check and modify its parameters remotely.
- Automatic identification of system voltage.
- It supports the charging of sealed GEL, sealed lead acid and lithium batteries.
- With its 3-stage PWM algorithm, it can give equalization charge to the batteries to prolong the life of the batteries.
- Use temperature compensation to adjust the use of the batteries.
- Equipped with LCD to check the status and configure the equipment.
- TVS lighting protection.
- Rated current 30A.
- System voltage 12V/24V.
- Rated power 12V 450W - 24V 900W.
- Maximum voltage in panels <55V.
- Maximum voltage in batteries <34V.
- Protection IP30
- Protection against short circuit of the batteries, reversed poles in the batteries, open circuit, load over current, overload, short circuit, over temperature.
- Model - HP2430
- Rated current - 30A
- System voltage - 12V/24V automatic detection
- Nominal power - manual configuration 12V/450W 24V/900W
- Loss without load - <13mA/12V; <15mA/24V
- Max. Solar energy input voltage - <55
- Max. voltage at the extreme of the battery - <34V
- Battery Type (× 1 / 12V; × 2 / 24V) - FLD (flooded) / SLD (sealed) / GEL / LI (lithium)
- Protection against overvoltage - 16.0V
- Increase the load voltage - 14.8 / 14.6 / - / -
- Floating load voltage - 13.8 / 13.8 / 13.8 / -
- Voltage of load recovery - 13.2V
- Voltage of recovery by over-discharge - 12.5V (configurable with the keys)
- Overvoltage voltage - 11.0V (configurable with the keys)
- Interval of equalization charge - 30 days
- Match the charging time - 1H
- Increase the charging time - 2H
- Temperature compensation - -3.0mV/℃ /2V
- Light control voltage - Light control in 5V, light control 6V (light control in plus 1V)
- Light control trial time - 10 minutes
- USB function - Yes
- Bluetooth - Optional function
- Operating temperature - -25℃ to +55℃
- IP protection grade - IP30
- Net weight - 390g
- Protection functions:
* Battery plate reverse connection protection note 1, a reverse connection protection note for battery 2
* Short circuit protection charge of the battery plate, open circuit protection charge of the battery
* Current protection load, overload protection, load short-circuit protection controller and protection excessive temperature.
- Dimensions - 164.0 × 103.5 × 47.0 (mm)